HP jetdirect 175x Administrator's Manual page 56

Table 3.3 TFTP Configuration File Parameters (3 of 10)
write-mode:
Controls the setting of the TCP PSH flag for device-to-client data transfers.
0 (default): disables this option, flag is not set.
1: all-push option. The push bit is set in all data packets.
2: eoi-push option. The push bit is set only for data packets that have an
End-of-Information flag set.
mult-tcp-conn:
Enables or disables multiple TCP connections.
0 (default): allows multiple connections.
1: disables multiple connections.
TCP/IP Raw Print Ports
raw-port:
Specifies additional ports for printing to TCP port 9100. Valid ports are 3000 to
9000, which are application-dependent.
TCP/IP Access Control
allow: netnum [mask]
Makes an entry into the host access list stored on the HP Jetdirect print server.
Each entry specifies a host or network of hosts that are allowed to connect to the
printer. The format is "allow: netnum [mask]" where netnum is a network number
or host IP address, and mask is an address mask of bits applied to the network
number and host address to verify access. Up to 10 access list entries are allowed.
If there are no entries, all hosts are permitted access. For example,
allow: 192.0.0.0 255.0.0.0 allows hosts on network 192.
allow: 192.168.1.2 allows a single host. In this case, the default mask
255.255.255.255 is assumed and is not required.
allow: 0 This entry clears the host access list.
For additional information, see
TCP/IP Other Settings
syslog-config:
Enables or disables syslog server operation on the print server: 0 disables,
1 (default) enables.
syslog-svr:
The syslog server's IP address. It specifies the server that the HP Jetdirect print
server sends syslog messages to. For more information, see
syslog-max:
Specifies the maximum number of syslog messages that can be sent by the
HP Jetdirect print server on a per-minute basis. This setting allows administrators
to control the log file size. The default is 10 per minute. If it's set to zero, the number
of syslog messages is not restricted.
ENWW
Chapter 7.
Appendix
TCP/IP Configuration 56
A.