HP jetdirect 175x Administrator's Manual page 59

Table 3.3 TFTP Configuration File Parameters (6 of 10)
default-ip:
Specifies the IP address to use when the print server is unable to obtain an IP
address from the network during a forced TCP/IP reconfiguration (for example,
when powered off/on or manually configured to use BOOTP/DHCP).
DEFAULT_IP: sets the legacy default IP address 192.0.0.192.
AUTO_IP: sets a link-local IP address 169.254.x.x.
The initial setting is determined by the IP address obtained when first powered on.
default-ip-dhcp:
Specifies whether DHCP requests will be periodically transmitted when a legacy
default IP address 192.0.0.192 or link-local IP address 169.254.x.x has been
automatically assigned.
0: Disables DHCP requests.
1 (default): Enables DHCP requests.
web-refresh:
Specifies the time interval (1 -99999 seconds) for embedded Web server
diagnostic page updates. If set to 0, the refresh rate is disabled.
SNMP
snmp-config:
Enables or disables SNMP operation on the print server. 0 disables, 1 (default)
enables SNMP.
CAUTION: Disabling SNMP will disable all SNMP agents (SNMP v1, v2, v3) as
well as communications with HP Web Jetadmin. In addition, firmware upgrades
through current HP downloading utilities will be disabled.
get-cmnty-name:
Specifies a password that determines which SNMP GetRequests the HP Jetdirect
print server will respond to. This is optional. If a user-specified get community name
is set, the print server will respond to either a user-specified community name or
the factory-default. The community name must be ASCII characters. The
maximum length is 255 characters.
set-cmnty-name:
Specifies a password that determines which SNMP SetRequests (control
functions) the HP Jetdirect print server will respond to. The community name of
an incoming SNMP SetRequest must match the print server's "set community
name" for the print server to respond. (For additional security, you may limit
configuration access through the print server's host access list). Community
names must be ASCII characters. The maximum length is 255 characters.
auth-trap:
Configures the print server to send (on) or not send (off) SNMP authentication
traps. Authentication traps indicate that an SNMP request was received, but the
community name check failed. The default is "on."
ENWW
TCP/IP Configuration 59