HP iPAQ h6310 User Manual page 108

2. On the iPAQ Wireless screen, tap the Wi-Fi button to turn it
on, then tap the Settings button next to it.
3. Tap the Wireless tab > Add New Settings.
4. Tap the General tab and enter a network name (SSID).
NOTE:
automatically entered and cannot be changed.
5. In the Connects to: box, select where your network connects
to (The Internet or Work).
6. If you want to connect to an ad-hoc connection, tap the This
is a device-to-computer (ad-hoc) connection checkbox.
7. If authentication information is needed, from the Settings
screen, tap Configure Wireless Networks.
NOTE:
needed, see your network administrator.
8. In the box next to Authentication:, tap the arrow for the
drop-down list, and select the type of network authentication
to use.
a. In the box next to Data Encryption, tap the arrow for the
b. If a network key is provided by your network
c. To use Shared Key authentication, type the network key
d. For increased security, check the Enable network
7–6
If a network was detected in step 2, the SSID is
To determine whether authentication information is
drop-down list, and select the type of Data encryption
(WEP enabled) to use.
automatically, check the The Key is provided for
me automatically checkbox.
in the Network Key: box.
access using IEEE 802.1X checkbox. You should
only check this option if it is supported by your network
environment. Ask your network administrator if you are
unsure.
Using Wi-Fi
User's Guide