Front-Panel Leds; Front Panel Leds - HP StorageWorks SR2122 User Manual

physical medium. See
specifications. Each Fibre Channel port has LEDs indicating its status, as
described in the "Front Panel LEDs" section that follows.

Front-Panel LEDs

The front-panel LEDs provide status indications about the storage router chassis
and its ports (see
■
■
■
■
■
Figure 4: Front panel LEDs
1
2
3
4
5
IP Storage Router SR2122-2 User Guide
Chapter B, "Cable and Port Pinouts"
Figure
Each Gigabit Ethernet port, GE 1 and GE 2, has four LEDs, labeled LINK,
RX, TX, and FAULT. The LEDs are located to the left and right of each
Gigabit Ethernet port.
The FAULT, STATUS, and POWER LEDs indicate the overall status of the
storage router. The LEDs are located to the left of the CONSOLE port.
The 10/100 Ethernet management port, MGMT 10/100, has two LEDs,
labeled ACT and SPEED. The ACT LED is located at the left-bottom corner
of the port; the SPEED LED is located at the right-bottom corner of the port.
The 10/100 Ethernet HA port, HA 10/100, has two LEDs, labeled ACT and
SPEED. The ACT LED is located at the left-bottom corner of the port; the
SPEED LED is located at the right-bottom corner of the port.
Each Fibre Channel port has two LEDs, labeled LINK and FAULT. The LEDs
are located to the left and right of each Fibre Channel port.
1 2 3 4
FC 1 LINK
FC 1 FAULT
FC 2 LINK
FC 2 FAULT
FAULT, STATUS, POWER
4).
hp StorageWorks IP storage router 2122-2
5 6 7
6
7
8
9
for SFP module
8 9
15004
GE 1 LINK and RX
GE 1 TX and FAULT
GE 2 LINK AND RX
GE 2 TX and FAULT
Product Overview
23