Prerequisite Tasks; Configuration Tasks - HP StorageWorks SR2122 User Manual

Configuring SCSI Routing

Prerequisite Tasks

Before configuring SCSI routing, make sure you have configured all system
parameters as described in
Chapter 6, "Configuring System Parameters"
If the VLAN service is to be used with the storage router, configure VLANs as
described in

Configuration Tasks

To configure SCSI routing on your storage router:
1. Create a SCSI routing instance. Once an instance is created, you will
2. Configure the server interface with or without VLAN.
3. Configure iSCSI targets.
4. Configure an access list that identifies which IP hosts can access iSCSI targets
5. Configure access. This identifies which IP hosts can access the iSCSI targets
6. Verify and save configuration.
Note:
at any point in the process of performing the configuration tasks. Save your
configuration by using the save all bootconfig CLI command. This command
saves all configuration data to the bootable configuration, which is then used when the
storage router is rebooted.
120
Chapter 7, "Configuring VLAN"
configure that instance with parameters for a server interface, iSCSI targets,
and access by IP hosts.
configured as part of a SCSI routing instance. An access list is necessary if
you want to specify access to iSCSI targets on a per-IP host basis. An access
list is not necessary if you want to specify that all IP hosts have access to the
iSCSI targets configured in a SCSI routing instance. (Optional)
configured as part of a SCSI routing instance.
Although this is shown as the last step, you can verify and save the configuration
Chapter 5, "Configuring the Storage Router"
before proceeding.
IP Storage Router SR2122-2 User Guide
or