Table of Contents
Advertisement
Configuring the Storage Router
Starting a CLI Management Session
Follow these steps to start a CLI management session via a Telnet connection to
the storage router.
1. Establish a Telnet session to the storage router.
2. Enter the appropriate password at the logon prompt.
3. Enter enable to change to Administrator mode. (Optional)
Note:
to enable the Administrator mode.
4. Enter the Administrator password at the prompt. (Optional)
5. Issue the appropriate CLI commands to complete the desired task.
Introducing the Web-Based GUI
As an alternative to the CLI, you can configure your storage router using the
web-based GUI. You can use the GUI for configuration after completing the initial
system configuration script, which assures that the storage router management
interface is configured with an IP address.
To access the GUI, enter the URL for the storage router by pointing your browser
to the storage router management interface IP address using the HTTP protocol
(for example, type http://10.1.10.244).
Logging In
After entering the URL for your storage router, a login page appears. You can log
in as monitor or as admin, and you will be asked for your user name and
password. See
the two login options. If you already configured new passwords for the monitor
and/or the administrator mode, use them when logging in.
Table 14: Logging into the Web-Based GUI
Login Options
Monitor
Admin
94
If you need to make changes to the configuration of the storage router, you need
Table 14
for the user name and factory default password to use for
User Name
monitor
admin
Factory Default Password
hp
hp
IP Storage Router SR2122-2 User Guide
Advertisement
Table of Contents
Troubleshooting
