Advertisement
3. Attach the joint guard to the gearbox guard using 2
shoulder bolts, 2 spring washers, and 2 nuts (1/4 inch)
as shown in
Figure
4.
Figure 4
1. Nut (1/4 inch)
2. Spring washer
3. Gearbox guard
4. Slide the posts of the drive-assembly guard through the
slots in the guard mount
Figure 5
1. Gearbox
2. Bolt (3/8 x 1/2 inch)
5. Attach the gearbox guard to the gearbox using 4 bolts
(3/8 x 1/2 inch) as shown in
4. Joint guard
5. Shoulder bolt
(Figure
5).
3. Drive-assembly guard
posts
Figure
5.
2
Installing the PTO Guards
Parts needed for this procedure:
1
Left PTO guard
1
Right PTO guard
1
Grommet
2
Bolt (3/8 x 7/8 inch)
2
Washer (7/16 inch)
2
Locknut (3/8 inch)
2
Bolt (5/16 x 1/2 inch)
4
Washer (3/8 inch)
2
Bolt (5/16 x 3/4 inch)
2
Nut (5/16 inch)
1
Safety decal (108-6585)
1
Safety decal (131-1944)
1
Safety decal (131-3393)
Procedure
Note: If there are no mounting holes in the frame, drill 2
holes (7 mm or 0.28 inch diameter) as shown in
1. 48 cm (19.0 inches)
2. 17.5 cm (6.9 inches)
6
Figure
Figure 6
3. Hole—7 mm (0.28 inch)
diameter
6.
Advertisement
