Changing The Start And End Angles Of The Stitch Pattern (Stitch Tapering Function) - Brother 882-W73 Operation Manual

Changing the Start and End Angles of the
Stitch Pattern (Stitch Tapering Function)
The angles of the start and end of stitch patterns can be
changed. This is useful when sewing projects with sharply
defined angles or decorative stitching, attaching appliqués,
etc.
Use the method for finishing sewing the stitch pattern,
according to your needs.
• Method 1: Begin Changing the Angle at the End of
Sewing by Pressing the "Reverse Stitch" Button
(page 93)
• Method 2: Sewing a Specified Number of Stitch
Patterns (page 94)
Note
• Using the same material and stitch pattern as your
project, sew trial stitches to check the result. If
necessary, attach a stabilizer material.
• If reinforcement stitches at the beginning and end
of sewing are needed, use
stitch button). (Reverse stitch button) cannot
be used for reinforcement stitching when stitch
tapering function is on.
 Method 1: Begin Changing the Angle at the
End of Sewing by Pressing the "Reverse Stitch"
Button
a
Touch , then
pattern for stitch tapering.
(Reinforcement
, and then select a stitch
b
If necessary, change the stitch width and stitch length.
c
Touch .
d
Touch , select the angle settings for the start and
end of sewing, and then touch
1 Select the start or end of sewing.
2 Select an angle.
3 Specify that the angle does not change.
UTILITY STITCHES
3
.
1
2
3
93