HP Visualize c100 Install Manual page 9

Figure 4
2 Hook the fan assembly into the slots on the storage tray. See 1 in Figure 5.
3 Lay the fan assembly down onto the storage tray. See 2 in Figure 5.
4 If present, reconnect the floppy disk drive I/O cable to the disk interconnect
5 Reconnect the human interface cable to its connector on the left side of the disk
6 Reconnect the power cables to storage devices and disk interconnect board.
7 Insert the tab on the new disk interconnect board into the notch in the storage tray.
Storage Device Cable Routing
board. Ensure the floppy I/O cable is routed under devices in positions 3 and 4.
interconnect board. Ensure the human interface cable is routed under devices in
positions 3 and 4.
See 3 in Figure 5.
Installing the Fan Assembly and Disk Interconnect Board
7