HP Visualize c100 Install Manual page 10

Installing the Fan Assembly and Disk Interconnect Board
8 Secure the disk interconnect board and fan assembly with the new thumb screws
CAUTION: Be very careful not to pinch any cables or wires when securing the new disk
interconnect board.
9 Connect the fan power cable to the two pin connector just below and to the left
4
Figure 5
10 Reconnect storage device I/O cables from positions 1 and 2, to the new disk
8
received in the upgrade kit. See 4 in Figure 5.
of the power distribution connector. See 5 in Figure 5.
2
3
Installing the Fan Assembly onto the Storage Tray
interconnect board, ensuring the cables are routed on top of the fan assembly,
alongside the fan itself. See Figure 6
1
5