HP Vectra XM5 3 User Manual page 45

NOTE
Using the ISA Configuration Utility (ICU)
You can use the ICU to configure Plug and Play accessory boards if
Plug and Play Device Management
in the SETUP program.
The ICU can also determine the recommended settings for each ISA
non-Plug and Play board you want to install. These settings may be
different from those recommended by the accessory board's
manufacturer. In this case, the board's jumper settings and driver
options must be altered.
To run the ICU:
1 Double-click on the Plug and Play group icon
Program Manager.
2 Double-click on the ICU Notes icon
about the Plug and Play support for your PC.
3 Double-click on the ICU User Guide icon
information about using the ICU.
4 Double-click on the ICU icon
Utility and configure system resources for the accessory board.
The ICU is preloaded with configuration details for many non-Plug
and Play accessory boards. If your accessory board is not listed by
the ICU, you have two options:
a Some non-Plug and Play accessory boards are supplied with a
configuration file, which can be used by the ICU to determine
which resources are required by the board. Insert the disk
containing the configuration file when prompted by the ICU.
b If you do not have a configuration file for your accessory board,
you will need to enter the configuration details manually when
prompted by the ICU. Refer to the documentation supplied with
your accessory board for information on the resources required
by the board.
You do not need to run the ICU when you install a PCI accessory board.
PCI accessory boards are automatically configured when installed in
your PC.
3 How to Install Accessories Inside Your PC
Installing Accessory Boards
is set to or
None
in the Windows
for up-to-date information
for detailed
to launch the ISA Configuration
Boot Only
English 33