Floppy Disk Drive - QUANTA CPV4-M Manual

Note: 2 Item5: There is one option for Single LED
Function Support On BIOS Menu

Floppy Disk Drive

The motherboard has a floppy disk drive interface (FLOPPY) that will
support one or two floppy disk drives. The floppy disk drive (FDD) rib-
bon cable has connectors for two 3.5-inch wide disk drives.
Note: The pin-1 side of the FDD ribbon cable is marked with a red
stripe
1. Install the FDD into a suitable drive bay in your computer case.
2. Locate the FDD connector on the motherboard. The connector
is named FLOPPY. Plug one end of the FDD ribbon cable into
FLOPPY. Plug one of the other connectors into the data con-
nector on the rear edge of the FDD module.
3. Plug a free power supply cable from the case power-supply
unit into the power connector on the rear edge of the floppy
disk drive.
4. When you start up your assembled computer, the floppy disk
drive will be identified as drive A. If you have installed two drives
on the cable, they will be identified as drives A and B.
5. Run the setup utility to configure the floppy disk drives. See
the following chapter for more information.
FLOPPY
23