Set The Jumpers; Jumper Location - QUANTA CPV4-M Manual

Set the Jumpers

This motherboard has jumpers that need to be set correctly. Jumpers are
sets of two, three, or more pins. You can use a jumper cap to connect two
adjacent pins. When a jumper cap connects two pins, we say that the pins
are SHORT. If you remove a jumper cap from two pins, we say that the pins
are OPEN. The illustrations below show the different positions of a jumper
cap on a typical 3-pin jumper. By changing the jumper cap, you change the
circuits of the motherboard and enable or disable certain features or proper-
ties of the board.
3-pin jumper 3-pin jumper 3-pin jumper
(no jumper cap) (pins 1-2 SHORT) (pins 2-3 SHORT)

Jumper Location

The illustration below shows the location of the jumpers on the main-
board:
15