Table of Contents
Advertisement
Fit the fire to the plinth
Lift the fire onto the plinth and feed the gas supply tube through the hole in the back corner. The fire needs to be set
approximately 20 mm back from the plinth, then slip forward so the bottom edge of the fire back panel sits under
the back edge of the fire mounting plate.
Fix in place with 2 x M5 screws through the front edge of the fire, circled below.
M5 Fixing Screws
Connect services and commission
Connect the power and gas. Fit the underside covers, and commission as per the commissioning instructions on
page 30.
Rinnai
Fire mounting plate
Alternate flex
power cord
routing
21
INSTALLATION
Fire back
panel
Hard wiring
option
Underside cover
must be fitted to
protect wiring
SS850 Freestanding IM
Advertisement
Table of Contents
