Table of Contents
Advertisement
INSTALLATION
Assemble outer plinth panels
Working on a flat surface assemble the outer plinth panels as shown. Take care to ensure the plinth is square and
that the top surfaces are flush with each other.
Fit panels to the base mounting plate
Fit the plinth to the base mounting plate by lifting the back edge of the plinth and sliding the front edge under the
front lip of the base plate, then setting the edge back down. Hold in place with three screws.
Fix fire base plate to plinth
Fix the fire base plate to the top of the plinth assembly using the stiffening rails as shown. Fit the second flexi pipe
supplied with the fire if required.
Check aeration setting
Check that the correct aeration shutter plates are fitted, (refer to page 15). It is still possible to change the
aeration setting once the fire is installed, however it is much easier to do this beforehand.
Rinnai
20
SS850 Freestanding IM
Advertisement
Table of Contents
