Network; Chapter 9 Network; Overview; What You Can Do In This Chapter - ZyXEL Communications NWA90AX User Manual

9.1 Overview

This chapter describes how you can configure the management IP address and VLAN settings of your
Zyxel Device.
The Internet Protocol (IP) address identifies a device on a network. Every networking device (including
computers, servers, routers, printers, etc.) needs an IP address to communicate across the network.
These networking devices are also known as hosts.
Figure 45 IP Setup
The figure above illustrates one possible setup of your Zyxel Device. The gateway IP address is 192.168.1.1
and the managed IP address of the Zyxel Device is 192.168.1.2 (default), but if the Zyxel Device is
assigned an IP address by a DHCP server, the default (192.168.1.2) will not be used. The gateway and
the Zyxel Device must belong in the same IP subnet to be able to communicate with each other.

9.1.1 What You Can Do in this Chapter

• The IP Setting screen
• The VLAN screen
• The NCC Discovery screen
Center (NCC) discovery settings.

9.2 IP Setting

Use this screen to configure the IP address for your Zyxel Device. To access this screen, click
Configuration > Network > IP Setting.
(Section 9.2 on page
(Section 9.3 on page 71) configures the Zyxel Device's VLAN settings.
(Section 9.4 on page
NWA50AX/NWA90AX/NWA55AXE Series User's Guide
C
H A P T E R
69) configures the Zyxel Device's LAN IP address.
74) configures the Zyxel Device's Nebula Control
69

Network

9