Run The Zon Utility - ZyXEL Communications NWA90AX User Manual

Note: To check for your Windows operating system version, right-click on My Computer >
Properties on your computer. You should see this information in the General tab.
Note: It is suggested that you install Npcap, the packet capture library for Windows operating
systems, and remove WinPcap or any other installed packet capture tools before you
install the ZON utility.
Hardware
Here are the minimum hardware requirements to use the ZON Utility on your PC.
• Core i3 processor
• 2 GB RAM
• 100 MB free hard disk
• WXGA (Wide XGA 1280x800)

2.3.2 Run the ZON Utility

Double-click the ZON Utility to run it.
1
The first time you run the ZON Utility, you will see if your device and firmware version support the ZON
2
Utility. Click the OK button to close this screen.
Figure 8 Supported Devices and Versions
Chapter 2 AP Management
NWA50AX/NWA90AX/NWA55AXE Series User's Guide
23