Cleaning And Maintenance - Dometic Oceanair Skysol Powered Roofblind Installation And Operating Manual

Cleaning and maintenance

I
NOTE
• When operating the blind using switches or an automation
system: If the movement direction is reversed too quickly, the motor might
not detect the polarity change and will just stop. To prevent this, the power
must be off for at least 0.5 seconds before the movement direction is
reversed.
• When the motor is stopped the power consumption falls to 8.5 mA. After
approximately 4 minutes the motor automatically switches off.
• Only if operated by switches: When operating the blind with switches
each switch operates each blind independently.
• Only if operated with the AP Remote control: When operating the blind
with the AP Remote control each blind is independently operated via sepa-
rate channels on the remote control (except the DM version when both
blinds operate at the same time).
• Each blind can be stopped in any position.
• When operating the blind with an automation system, the operation is
dependent on the programming of the control interface.
• The blind automatically stop
– when the blind is fully deployed
– when the blind is fully stowed
– if the blind hits an obstruction (including the other moving rail)
9 Cleaning and maintenance
A
NOTICE! Risk of damage
• Do not grease, oil or lubricate the blind. Lubricants will damage the fabric.
• Be careful not to crease the fabric when using the brush attachment of a
vacuum cleaner.
• Rubbing can damage fabrics. Do not scrub.
• Spot-cleaning may result in cleaner areas than the surrounding.
• Do not soak the blinds.
• The manufacturer recommends testing any cleaning agents on a hidden
area of the blind first.
I
NOTE Cleaning by professional cleaning personnel
The manufacturer cannot be held liable for improper cleaning methods or
agents used by professional cleaning personnel. In this case the responsibility
lies with the cleaning company.
Removing dust
➤ Dust the blind regularly with a dust rag, dust glove or a vacuum cleaner with
a brush attachment. Blow excess dust off of your fabric using a can of com-
pressed air or a hair dryer on a cool setting.
26
Skysol Powered Roofblind
EN