Troubleshooting - Dometic Oceanair Skysol Powered Roofblind Installation And Operating Manual

Skysol Powered Roofblind
➤ Fully deploy the blind to clean the fabric.
➤ Fully stow the blind to clean around side tracks or frame.
Spot cleaning
➤ Spot-clean with a soft white cloth, moistened with warm water, add a mild
detergent if needed (non-abrasive and with no additives).
➤ Blot gently to avoid creasing or damaging the fabric. Always leave the blind
deployed to dry thoroughly.
Removing bugs
➤ To prevent damage to delicate fabrics, do not use any type of stick, wand or
handle to push out anything caught in your blinds. We recommend gently
blowing out using either a can of compressed air or a hair dryer on a cool
setting.
➤ The blind panels can be removed for cleaning.
Cleaning windows
➤ Always ensure your blinds are fully stowed before cleaning windows. This will
prevent spoiling the blind fabric by splatter or sprays of water or detergent.
Panels can be unclipped and removed for fabric cleaning (fig. h, page 11 to
fig. i, page 11).
10

Troubleshooting

Fault
Moving rail not straight.
Panel not fully deploying.
Motor not working.
Motor running slow or fast.
Remote control (optional)
not operating.
EN
Solution
➤ Disconnect the first fabric panel at the opposite end
to the crooked moving rail (fig. h, page 11 to
fig. i, page 11).
➤ Adjust the coupling (fig. b, page 8).
➤ Disconnect the panel behind the non-working panel
to expose the cords (
page 11).
➤ Check for any cord that maybe caught or crossed
and re-connect (fig. d, page 9).
➤ Check if wiring for voltage to the motor is correct.
➤ If power supply is checked and the motor is still
faulty contact your distributor.
➤ If using the AP Remote control refer to the AP
Remote control manual.
➤ Check for correct supply voltage.
➤ Refer to the remote control manual.
Troubleshooting
fig. h
fig. i,
to
, page 11
27