Step 5: Fence Guide And Power Control Box - Delta 36-725 T2 Quick Assembly Manual

Step 5: FENCE GUIDE AND
POWER CONTROL BOX
Hardware Bag "E"
1.
Attach the Right Fence Guide
inch Button Head Hex Screw with Split Lock Washers
through the holes on the bottom side of the Front Rail. See
Figure 13.
2.
Attach the Left Fence Guide to the Front Rail
1/4-20 x 1/2 inch Button Head Hex Screw with Split Lock
Washers through the right two holes on the bottom
HP18
side of the left half Front Rail
screws loose until the control box screws are started.
3.
Align the two holes in the Switch Box Bracket with the
holes underneath the Front Rail
on the left side of the saw. Secure the Power Control Box
to the Front Rail
PC19
with Split Lock Washers
Left and Right Fence Guides are parallel. See Figure 15.
NOTE: To tighten the bolts that fasten the switch, you may need
to use a 12mm open-ended wrench.
4.
Fix the hanging Power Cord at rear side of Front Rail by
Wire Clip and M5 x 6mm Phillips Head Screw
HP17
Figure 16.
using (3) 1/4-20 x 1/2
PC20
PC20
. NOTE: Leave these
PC19
, see Figure 14, located
PC19
using (2) 1/4-20 x 1/2 inch Hex Screw
. Use a ruler to check that both
HP19
HP18
using (2)
. See
HP16
RIGHT FENCE
GUIDE (LONG)
Figure 13
LEFT FENCE LEFT FENCE
GUIDE (SHORT) GUIDE (SHORT)
PC20
HP19
CONTROL BOX CONTROL BOX
Figure 14
STRAIGHT EDGE STRAIGHT EDGE
Figure 15
HP19
BACK BACK
Figure 16
PC20
HP18
HP18
HP16
HP17