Installing A Hard Disk Drive - HP Net PC 20 Supplementary Manual

Installing a Hard Disk Drive

Installing a Hard Disk Drive
To install a hard disk drive, take the following steps.
1 Remove the cover (refer to "Removing the Cover" on page 14).
2 Remove the front panel chassis (refer to "Removing the Front Panel Chassis"
on page 16).
3 Slide the new hard disk drive on to the hard disk drive shelf and, using the four
screws supplied with the drive, secure the drive in position.
4 Connect the IDE cable and the power supply cable to the hard disk drive.
5 Place the front panel chassis slightly in front of the main chassis.
6 Connect the other end of the IDE cable to the PRIMARY connector on the
system board (refer to "System Board and Backplane" on page 12).
7 Connect the power cable coming from the back of the hard disk drive to the
HDD_PW connector on the system board (refer to "System Board and
Backplane" on page 12).
8 Replace the front panel chassis (refer to "Replacing the Front Panel Chassis"
on page 17).
9 Replace the cover (refer to "Replacing the Cover" on page 15).
18
Hard disk drive
Red edge Pin 1