Removing The Front Panel Chassis - HP Net PC 20 Supplementary Manual

Removing the Front
Panel Chassis

Removing the Front Panel Chassis

Removing the Front Panel Chassis
To gain full access to the system board you need to remove the front panel
chassis.
1 Remove the PC's cover as described in "Removing the Cover" on page 14.
2 Using a screwdriver, remove the two screws holding the front panel chassis in
place.
3 Disconnect any cables that run between the front panel chassis and the system
board, for example, the hard disk drive data and power cables.
4 Slide the front panel chassis away from the PC and place the chassis slightly in
front of the PC. If you have not disconnected the cables from the system board,
take care not to put any strain on the cables as you slide the front panel chassis
clear of the PC.
16