Rtu Slave Mode - Planet Networking & Communication Modbus Gateway Series User Manual

Buttons
: Click to apply port config changes.
When applying any configuration changes of Modbus Gateway, it's required to
configuration and reboot

4.5.2.2 RTU Slave mode

This function allows the users to use Modbus TCP master device and Modbus RTU device to achieve communication. The
operation mode of the Industrial Modbus Gateway is set to RTU Slave. The remote pair master/slave topology in
appears.
The remote pair master mode screenshot in
User's Manual of MG-11x Modbus Gateway Series
Figure 4-5-4: Disable Mode Screenshot
system. Therefore the new configuration will be applied after rebooting.
Figure 4-5-5: RTU Slave Topology
Figure 4-5-6 appears.
48
save changed
Figure 4-5-5