Power Information - Planet Networking & Communication Modbus Gateway Series User Manual


Reset button
On the rear panel, the
button functions:
Reset Button
System Reset
2.1.6

Power Information:

The central pole of the Modbus Gateway's power jacks measures 2.5mm wide that require +5VDC power input. It conforms to
the bundled AC-DC adapter and PLANET's media chassis. Should you have the issue of power connection, please contact your
local sales representative.
Please keep the AC-DC adapter as a spare part when the Modbus Gateway is installed in a media chassis.(MG-110/115A)
2.5mm
Width of DC Receptacle: 2.5mm
+5V for each slot
DC receptacle is 2.5mm wide that matches the central pole; the width of the Modbus
Gateway DC jack also measures 2.5mm.
Warning: Do not install any improper unit.
The device is a power-required device, meaning it will not work till it is powered. If your networks should be active all the time,
please consider using UPS (Uninterrupted Power Supply) for your device. It will prevent you from network data loss or network
downtime.
In some areas, installing a surge suppression device may also help to protect your Modbus Gateway from being damaged by
unregulated surge or current to the converter or the power adapter.
reset button is designed for rebooting the system. The following is the summary table of the reset
Reset Button Pressed and Released
< 5 sec: System reboot
> 5 sec: Factory default
User's Manual of MG-11x Modbus Gateway Series
Function
Reboot the Modbus Gateway
Reset the Modbus Gateway to Factory
Default configuration. The Modbus
Gateway will then reboot and load the
default settings as shown below:
。
Default Username: admin
。
Default Password: admin
。
Default IP address: 192.168.0.100
。
Subnet mask: 255.255.255.0
。
Default Gateway: 192.168.0.254
21