Table of Contents
Advertisement
4. WEB CONFIGURATION
This section introduces the configuration and functions of the Web-based management from Modbus Gateway.
About Web-based Management
The Modbus Gateway offers management features that allow users to manage the Modbus Gateway from anywhere on the
network through a standard browser such as Microsoft Internet Explorer.
The Web-based Management supports Internet Explorer 7.0. It is based on Java Applets with an aim to reduce network
bandwidth consumption, enhance access speed and present an easy viewing screen.
By default, IE7.0 or later version does not allow Java Applets to open sockets. The user has to explicitly
modify the browser setting to enable Java Applets to use network ports.
The Modbus Gateway can be configured through an Ethernet connection, making sure the manager PC must be set to the
same IP subnet address with the Modbus Gateway.
For example, the default IP address of the Modbus Gateway is 192.168.0.100, then the manager PC should be set to
192.168.0.x (where x is a number between 1 and 254, except 100), and the default subnet mask is 255.255.255.0.
If you have changed the default IP address of the Modbus Gateway to 192.168.1.1 with subnet mask 255.255.255.0 via console,
then the manager PC should be set to 192.168.1.x (where x is a number between 2 and 254) to do the relative configuration on
manager PC.
Logging on to the Modbus Gateway
1.
Use Internet Explorer 7.0 or above Web browser. Enter the factory default IP address to access the Web interface. The
factory default IP address is shown as follows:
Default IP Address: 192.168.0.100
Default Username: admin
Default Password: admin
User's Manual of MG-11x Modbus Gateway Series
Figure 4-1-1: Web Management
35
Advertisement
Table of Contents
