Memory Detection And Configuration - Compaq Deskpro EP 6233 Technical Reference Manual

7.3

MEMORY DETECTION AND CONFIGURATION

This system uses the Serial Presence Detect (SPD) method of determining the installed DIMM
configuration. The BIOS communicates with an EEPROM on each DIMM through an I
bus to obtain data on the following DIMM parameters:
Presence
Size
Type
Timing/CAS latency
NOTE: Refer to Chapter 3, "Processor/Memory Subsystem" for the SPD format and DIMM
data specific to this system.
The BIOS performs memory detection and configuration with the following steps:
1. Set Memory Buffer Strength – The memory controller must be configured for correct buffer
drive strength. The BIOS provides this function by reading the number of module banks,
ECC enable/disable status, and SDRAM width data from the DIMMs and transferring that
data to the memory controller. SPD bytes checked: 5, 11, 13
2. Determine DIMM Presence/Type – The BIOS checks each memory socket for DIMM
presence. If present, the DIMM type and CAS latency is determined. SPD bytes checked: 2,
9, 10, 18, 23, 24.
Check Sequence:
a. SPD byte 2 is read for all slots first. A failed read or returned value of other than 02h
(EDO) or 04h (SDRAM) results in the slot marked as empty. If mixed types are detected
then only SDRAMs are used (see chapter 3 for details).
b. SPD byte 18 is read for maximum CAS latency, followed by reads of bytes 9 and 10 for
bus speed compatibility. A DIMM detected as too-slow results in an error.
c. If the DIMM can handle the memory bus speed at maximum CAS latency then bytes 23
and 24 are checked to see if the DIMM can work maximum CAS latency minus 1. Once
all slots are checked, the greatest CAS latency (2 or 3) is used. A DIMM detected as
incompatible will result in a bit in CMOS being set and the Num Lock LED on the
keyboard will blink for a short time. Depending on the progress of the BIOS routine a
POST message may be displayed before the system locks up.
3. Initialize SDRAM – If SDRAM is installed then each row containing SDRAM will be
initialized. This step includes pre-charging all banks, sending a CAS-before-RAS command,
sending a Mode-Register-Set-Enable command, reading DIMM location/CAS latency data,
and sending a Normal Op command.
4. Memory Sizing – The SPD bytes 3, 4, and 17 are checked for number of row and column
addresses and (for SDRAM) the number of internal banks.
5. Memory Timing – For SDRAM, the memory controller requires the RAS pre-charge time
and the RAS-to-CAS delay time. SPD bytes checked: 27and 29.
Compa Deskpro EP Series of Personal Computers
First Edition- April 1998
Technical Reference Guide
2
C-type
7-3