Regulatory Agency Statements - ADEMCO VISTA-10SE Installation Instructions Manual

Hide thumbs Also See for VISTA-10SE:

Installation and setup manual (100 pages)

User manual (44 pages)

Programming manual (24 pages)

Table Of Contents

Table of Contents

This equipment has been tested to FCC requirements and has been found acceptable for use. The FCC

requires the following statement for your information:

This equipment generates and uses radio frequency energy and if not installed and used properly, that is,

in strict accordance with the manufacturer's instructions, may cause interference to radio and television

reception. It has been type tested and found to comply with the limits for a Class B computing device in

accordance with the specifications in Part 15 of FCC Rules, which are designed to provide reasonable pro-

tection against such interference in a residential installation. However, there is no guarantee that

interference will not occur in a particular installation. If this equipment does cause interference to radio or

television reception, which can be determined by turning the equipment off and on, the user is encouraged

to try to correct the interference by one or more of the following measures:

• If using an indoor antenna, have a quality outdoor antenna installed.

• Reorient the receiving antenna until interference is reduced or eliminated.

• Move the radio or television receiver away from the receiver/control.

• Move the antenna leads away from any wire runs to the receiver/control.

• Plug the receiver/control into a different outlet so that it and the radio or television receiver are on

different branch circuits.

If necessary, the user should consult the dealer or an experienced radio/television technician for additional

suggestions. The user or installer may find the following booklet prepared by the Federal Communications

Commission helpful: "Interference Handbook"

This booklet is available from the U.S. Government Printing Office, Washington, DC 20402.

The user shall not make any changes or modifications to the equipment unless authorized by the

Installation Instructions or User's Manual. Unauthorized changes or modifications could void the user's

authority to operate the equipment.

This equipment complies with Part 68 of the FCC rules. On the front cover of this equipment is a label that

contains, among other information, the FCC registration number and ringer equivalence number (REN) for

this equipment. If requested, this information must be provided to the telephone company.

This equipment uses the following jacks: An RJ31X is used to connect this equipment to the telephone

network.

The REN is used to determine the quantity of devices which may be connected to the telephone line.

Excessive RENs on the telephone line may result in the devices not ringing in response to an incoming call.

In most, but not all areas, the sum of the RENs should not exceed five (5.0). To be certain of the number of

devices that may be connected to the line, as determined by the total RENs, contact the telephone

company to determine the maximum REN for the calling area.

If this equipment causes harm to the telephone network, the telephone company will notify you in advance

that temporary discontinuance of service may be required. If advance notice is not practical, the telephone

company will notify the customer as soon as possible. Also, you will be advised of your right to file a

complaint with the FCC if you believe necessary.

The telephone company may make changes in its facilities, equipment, operations, or procedures that

could affect the operation of the equipment. If this happens, the telephone company will provide advance

notice in order for you to make the necessary modifications in order to maintain uninterrupted service.

If trouble is experienced with this equipment, please contact the manufacturer for repair and warranty

information. If the trouble is causing harm to the telephone network, the telephone company may request

you remove the equipment from the network until the problem is resolved.

There are no user serviceable components in this product, and all necessary repairs must be made by the

manufacturer. Other repair methods may invalidate the FCC registration on this product.

This equipment cannot be used on telephone company-provided coin service. Connection to Party Line

Service is subject to state tariffs.

This equipment is hearing-aid compatible.

When programming or making test calls to an emergency number, briefly explain to the dispatcher the

reason for the call. Perform such activities in the off-peak hours; such as early morning or late evening.

www.PDF-Zoo.com