Step 11 Perform Initial Test And Configuration - American Megatrends 42 Series User Manual

Step 11 Perform Initial Test and Configuration

Review the following before powering up the system:
✓ make sure that all adapter cards are seated properly,
✓ make sure all connectors are properly installed,
✓ if the math coprocessor is used, make sure it is seated properly,
✓ make sure there are no screws or other foreign material on the motherboard,
✓ plug the system into a surge-protected power strip, and
✓ make sure blank back panels are installed on the back of the chassis to minimize RF emissions.
Start the Test
Plug everything in and turn the unit on. If there are any problems, turn off the unit immediately. Reinstall the connectors. Call
Technical Support if there are additional problems.
BIOS Errors
If the system operates normally, a display should appear on the monitor. POST should execute.
If POST does not run successfully, it will beep or display error messages. If the system beeps, a serious problem exists with the
system configuration or hardware. The beeps are part of a Beep Code (see page ) that almost always indicates a bad or
improperly installed component. Make sure the affected part is properly seated and connected.
An error message can appear on the monitor if the error is less serious. Recheck the system configuration or the connections
and make sure proper installation procedures were followed.