Step 11 Perform Initial Test And Configuration - American Megatrends Enterprise-III User Manual

Step 10 Install Adapter Cards,
VL-Bus, cont'd
Pin Use
A26 ADR22
A27 VCC
A28 ADR20
A29 ADR18
A30 ADR16
A31 SA00
A32 ADR12
A33 ADR10
A34 ADR08
A35 GND
A36 ADR06
A37 ADR04
A38 WBACK#
A39 BE0#
A40 VCC
A41 BE1#
A42 BE2#
A43 GND
A44 BE3#
A45-47 A05#
A48 LRDY#
A49 LDEV<>#
A50 LREQ<>#
A51 GND
A52 LGNT<>#
A53 VCC
A54 ID5
A55 ID3
A56 ID4
A57 LKEN#
A58 LEADS#

Step 11 Perform Initial Test and Configuration

Before powering up the system:
_ make sure that all adapter cards are seated properly,
_ make sure all connectors are properly seated,
_ if a math coprocessor or Upgradable Processor is used, make sure it is seated properly,
_ make sure there are no screws or other foreign material on the motherboard,
_ plug the system into a surge-protected power strip, and
_ make sure blank back panels are installed on the back of the chassis to minimize RF emissions.
Enterprise-III EISA VLB Motherboard User's Guide
Continued
Pin Use
B26 ADR23
B27 ADR21
B28 ADR19
B29 GND
B30 ADR17
B31 GND
B32 VCC
B33 ADR13
B34 ADR11
B35 ADR09
B36 ADR07
B37 ADR05
B38 GND
B39 ADR03
B40 ADR02
B41 N/C
B42 RESET#
B43 D/C#
B44 M/IO#
B45-47 W/R#
B48 RDYRTN#
B49 GND
B50 IRQ9
B51 BRDY#
B52 BLAST#
B53 ID0
B54 ID1
B55 GND
B56 LCLK
B57 VCC
B58 LBS16#
77