Versal Acap Configuration - AMD XILINX VPK120 User Manual

Versal ACAP Configuration

The Versal XCVP1202 ACAP boot process is described in the "Platform Boot, Control, and
Status" section of the Versal ACAP Technical Reference Manual (AM011). The VPK120 board
supports a subset of the modes documented in the technical reference manual via onboard boot
options. The mode DIP switch SW1 configuration option settings are listed in the following table.
Table 5: Mode Switch SW1 Configuration Option Settings
Boot Mode
JTAG
QSPI32
SD1 (SD 3.0)
Notes:
1. Default switch setting.
2. Mode DIP SW1 poles [4:1] correspond to U1 XCVP1202 MODE[3:0].
3. Mode DIP SW1 individual switches ON=LOW (p/d to GND)=0, OFF=HIGH (p/u to VCCO)=1.
JTAG
The Vivado ® , Xilinx SDK, or third-party tools can establish a JTAG connection to the Versal
ACAP in the two ways described in this section.
• FTDI FT4232 USB-to-JTAG/USB-UART device (U20) connected to USB 2.0 type-A micro
connector (J344), which requires:
Set boot mode SW1 for JTAG as indicated in the "Mode Switch SW1 Configuration Option
○
Settings" table in
Set 2-pole DIP SW3[1:2] set to 01 (ON, OFF) for JTAG MUX channel 2 FT4232 U20
○
bridge.
On the 3-pin JTAG MUX, enable header J37 to enable the JTAG MUX. Move the 2-pin
○
jumper to be installed on pins 2-3. See
Board Component Location
Power-cycle the VPK120 evaluation board or press the power-on reset (POR) pushbutton
○
(SW2). SW2 is near the mode pin dip switch in the figure in
• JTAG pod flat cable connector J36 (2 mm 2x7 shrouded/keyed), which requires:
Set boot mode SW1 for JTAG as indicated in the "Mode Switch SW1 Configuration Option
○
Settings" table in
On the 3-pin JTAG MUX, enable header J37 to inhibit the JTAG MUX. Move the 2-pin
○
jumper to be installed on pins 1-2 for high-z mode. See
for defaults and
UG1568 (v1.0) August 9, 2022
VPK120 Board User Guide
Mode Pins [0:3]
1,3
0000
0100
0111
Versal ACAP Configuration.
Default Jumper and Switch Settings
for location.
Versal ACAP Configuration.
Board Component Location
Chapter 2: Board Setup and Configuration
2
Mode SW1 [1:4]
ON, ON, ON, ON
ON, OFF, ON, ON
ON, OFF, OFF, OFF
Board Component
Default Jumper and Switch Settings
for location.
Send Feedback
2
for defaults and
Location).
www.xilinx.com
19