Table of Contents
Advertisement
To install the hard drive, reverse this procedure.
Fingerprint reader
To remove the fingerprint reader, use this procedure and illustration.
Table 5-7
Fingerprint reader description and part number
Description
Fingerprint reader
Fingerprint reader cable
Before removing the fingerprint reader, follow these steps:
1.
Prepare the computer for disassembly (see
2.
Remove the bottom cover (see
3.
Remove the battery (see
4.
Remove the hard drive (see
Remove the fingerprint reader:
1.
Remove the Phillips M2.0 × 3.0 screw (1) that secures the fingerprint reader bracket to the computer, and
then remove the bracket (2).
2.
Disconnect the cable from the ZIF connector on the fingerprint reader board (3).
3.
Remove the fingerprint reader from the computer (4).
NOTE:
to replace the adhesive when installing a fingerprint reader. The adhesive is available in the fingerprint
reader spare part kit.
Bottom cover and rubber feet on page
Battery on page
Hard drive on page
The fingerprint reader is secured with adhesive that is easy to damage during removal. Be sure
Preparation for disassembly on page
32).
37).
Spare part number
M51625-001
M50424-001
30).
30).
Fingerprint reader
39
Advertisement
Table of Contents
