Table of Contents
Advertisement
Item
Mode Name
USB Test Mode
To Inspect USB Testing.
8.2.1.
CD Self-Adjustment (AJST) Result Display
Purpose: To display result of self-adjustment for CD.
Below is the procedures for this mode.
Step 1: Enter into Doctor mode (For more information refer to section 8.2 on key operation to enter into this mode).
Step 2: When [
], [1] & [4] are pressed at the doctor mode, the following shall be displayed for 3s. The result shall correspond
to the condition met as shown in the table below:
8.3.
Error Code Table 1
8.3.1.
Mechanism Error Code Table
Self-Diagnosis Function provides information on any problems occuring for the unit and its respective components by displaying
error codes. These error code such as U**, H** and F** are stored in memory and held unless it is cleared.
The error code is automatically display after entering into self-diagnostic mode.
Error Code
Diagnosis Contents Description of error
F15
CD
REST
abnormal
H15
CD OPEN SW
abnormal
Description
The display will appear after 3s,
SW
CD
traverse
position
initial setting operation
fail-safe
counter
(1000ms)
waiting
for
REST SW to turn on.
Error no. shall be clear
by force or during cold
start.
During normal operation,
if CD OPEN SW ON is
not detected within 4
sec, and then H15 shall
be memorized. The error
code can be cleared only
at the start up of micro-p
after reset.
FL Display
Automatic FL Display
17
Key Operation
Front Key
In doctor mode:
1. Select [USB
] for USB mode.
2. Press [2] button on remote control.
To exit, press [
] button on
main unit or remote control.
Remarks
For CD unit.(For traverse).
Press [ ] on main unit for next error.
For CD unit.(For traverse).
Press [ ] on main unit for next error.
SC-EN38GCS
Advertisement
Table of Contents
