Changing The Print Settings - Canon PIXMA MX7600 Series Quick Start Manual

Changing the Print Settings

The machine prints received faxes to paper from the specified paper source. You can change the
paper settings for printing faxes using the Operation Panel. Set them according to the loaded
paper properly.
Important
If no paper is loaded in a specified paper source, or paper has run out during printing, the received
faxes are stored in memory, then "There is no paper. Load paper and press OK." will be
displayed. In this case, load paper in the specified paper source and press the OK button.
You can also press the Stop/Reset button to close the message and print the stored documents in
memory later.
See "Printing a Document in Memory" on page 95.
Note
If the sender sends a document that is larger than Letter-size, such as 11" x17" or Legal-size, the
sender's machine may send the fax automatically shrunk or divided, or send only a part of the
original.
1
Press the FAX button.
2
Press the Settings button.
The FAX settings screen is displayed.
3
Use the { or } button to select the setting item.
4
Use the [ or ] button to change the setting.
(1) Select the page size from A4, 8.5" x 11" (215 x 279), or 8.5" x 14" (215 x 355).
(2) The paper type is set to Plain paper.
5
Press the Settings button.
The LCD returns to the FAX standby screen.
Setting the Number of Rings for Fax Calls
When FAX priority mode, FAX only mode, or DRPD (US and Canada only) is selected as the
receive mode, you can specify the number of rings for fax calls in Incoming ring in RX settings
under FAX settings.
Refer to "Incoming ring" in "Device Settings" of the User's Guide on-screen manual.
(1)
(2)
Faxing 93