Canon PIXMA MX7600 Series Quick Start Manual page 129

3
With a soft, clean, lint-free and dry cloth, wipe
off any paper dust from the inside of the
Document Feeder Cover (A).
4
After wiping, close the Document Feeder
Cover by pushing it until it clicks into place.
5
Close the Document Tray.
Cleaning the Paper Feed Roller (Roller Cleaning)
Clean the paper feed roller if paper is not fed properly. Cleaning the paper feed roller will wear
the roller, so perform this only when necessary.
Caution
The power cannot be turned off while the machine is sending or receiving a fax, or when there
are unsent faxes stored in the machine's memory.
The machine cannot receive faxes when the power is turned off.
If you unplug the power cord, all the documents stored in memory are deleted. Send or print
necessary documents before unplugging the power cord.
1
Make sure that the machine is turned on, and then remove any paper from the
Rear Tray and Cassette.
2
Clean the paper feed roller.
(1) Press the Menu button.
(2) Use the [ or ] button to select Maintenance/settings, then press the OK button.
The Maintenance/settings screen is displayed.
(3) Use the [ or ] button to select Maintenance, then press the OK button.
The Maintenance screen is displayed.
(4) Use the { or } button to select Roller cleaning, then press the OK button.
The confirmation screen is displayed.
(5) Use the { or } button to select Yes, then press the OK button.
(6) Use the { or } button to select Rear tray or Cassette, then press the OK button.
The Paper Feed Roller will rotate as it is cleaned.
3
Repeat (4) and (6) in step 2 twice.
4
Open the Paper Output Tray, and then open the Output Tray Extension.
(1) Press the Open button to open the Paper Output Tray.
(2) Open the Output Tray Extension.
5
Make sure that the paper feed roller stops rotating, then load three sheets of A4 or
Letter-sized plain paper in portrait orientation in the paper source you cleaned.
(A)
Routine Maintenance 125