Table of Contents
Advertisement
Problem
Residual heat indicator
has extinguished despite
zone(s) still being hot.
One or more heating
elements (glowing red
area) is switching on and
off periodically, producing a
click when doing so.
Hob top is broken, cracked
and/or chipped.
A fault has not been
resolved by any suggested
remedies or a fault code is
displayed
Should any error code show on the zone displays, or this guide's
steps not resolve an issue, please contact CDA Customer Care for
assistance. Contact details are below.
Contact CDA Customer Care
A: Customer Care Department, The CDA Group Ltd, Harby Road,
Langar, Nottinghamshire, NG13 9HY
T: 01949 862 012
E: customer.care@cda.eu W: www.cda.eu
16
Possible Causes
The appliance has no
power or the zone
temperature is lower than
the sensor can register.
This 'cyclic' function
is normal for this hob.
Ceramic zones produce
high heat levels and as
such cycle on and off,
particularly on lower heat
settings.
Stop using the appliance immediately and switch the
appliance off at the mains. Contact CDA Customer
Care to arrange a repair (contact details on page 16).
Contact CDA Customer Care using the contact details
on page 16 to arrange a service visit.
F: 01949 862 003
Possible Remedy
Check the fuse and
replace if blown.
No action needed.
Advertisement
Table of Contents
