Terex GS30MD-3169 Operator's Manual page 35

Second Edition • First Printing
52 Drive the machine.
Result: The machine should drive.
53 Return to level ground and raise the platform in
excess of approximately 7 ft / 2.13 m.
54 Drive the machine onto a slope where the pitch
angle is greater than 1.5° side to side.
Result: The machine should stop once the
machine reaches 1.5° of chassis tilt and the tilt
alarm will sound at 180 beeps per minute. The
platform controls LED readout should display
LL and the ground controls LCD should display
LL: Machine Tilted.
55 Return to level ground and fully lower the
platform.
56 Drive the machine onto a slope where the
chassis angle is greater than 2.5° front to back.
57 Raise the platform approximately 7 ft / 2.13 m.
Result: The platform should stop and the tilt
alarm will sound at 180 beeps per minute. The
platform controls LED readout should display
LL and the ground controls LCD should display
LL: Machine Tilted.
58 Press the drive function button.
59 Press and hold the drive/steer function enable
switch on the control handle.
Part No. 1301858GT
60 Move the control handle in the direction
indicated by the blue arrow, then move the
control handle in the direction indicated by the
yellow arrow.
Result: The drive function should not work in
either direction.
61 Fully lower the platform.
62 Drive the machine.
Result: The machine should drive.
63 Return to level ground and raise the platform in
excess of approximately 7 ft / 2.13 m.
64 Drive the machine onto a slope where the pitch
angle is greater than 2.5° front to back.
Result: The machine should stop once the
machine reaches 2.5° of chassis tilt and the tilt
alarm will sound at 180 beeps per minute. The
platform controls LED readout should display
LL and the ground controls LCD should display
LL: Machine Tilted.
65 Fully lower the platform and return to level
ground.
™
GS -1330m
Operator's Manual
Inspections
33