HP Brio 8200 Online Manual page 41

6 Install any other accessories before returning the computer to the upright position, replacing the cover, and
reconnecting the power supply cords and any telecommunications cables.
7 Turn on the display and then turn on the computer.
8 In Windows, check that the new memory has been recognized: right-click the My Computer icon on the desktop and
then click Properties in the drop-down menu.
Troubleshooting
If the new memory is not recognized, check that you have correctly followed the installation procedure described
above.
If there are any errors reported during the computer's startup routine, press
necessary action. If you have any doubts about using the Setup program, contact your reseller for help.
If you cannot start your computer properly, remove the memory and try starting your computer again. If the computer
now starts without any problems, there may be a problem with the new memory.
If you experience any other problems as a result of the upgrade, and your computer is supplied with the HP Brio Center,
refer to the support tools for further assistance.
Removing a
If you need to remove a main memory module, release the retaining clips at both ends of the socket. This raises the module
out of the socket. Handle the memory module by its edges, then lift it up and clear of the system board.
Memory Module
a. Release the
retaining clips
b. Lift the module up,
then out
3 Upgrading and Adding Accessories
Upgrading Hardware
to view the error(s) and take any
41