How To Recover If Things Go Wrong; System Boot Failure; Incorrect Password On Startup - HP Brio 8200 Online Manual

How to Recover if Things Go Wrong

System Boot Failure

If you have made some modifications in the Setup program and there is a system boot failure, you should do the
following:
1 Restart the computer, then press
Change the setting that you have modified to its original configuration, save it and exit the Setup program, then
continue with the system startup.
2 If the system still fails to start up, restart the computer, enter the Setup program, then press the
load the Setup default values to recover. However, by doing this, you will lose all customized settings in the Setup
program. These settings will have to be reconfigured.
HP strongly recommends that you take note of any change to the system setup and store it in a safe place. If you
Note
have any doubts about using the HP Setup program, contact your reseller for help.
If you are having problems with
values and reset the built-in default values. Refer to
this.

Incorrect Password on Startup

After three unsuccessful attempts to enter the correct password on Password on Boot, your computer becomes
disabled. If this happens, turn your computer off and then on again, then enter the correct password. If you have
forgotten your password, you need to clear the
for details on how to do this.
when Press <F2> to enter SETUP is displayed at the bottom of the screen.
POST error messages, you probably need to clear the current configuration memory
"Clearing the CMOS Configuration"
CMOS configuration. Refer to
How to Recover if Things Go Wrong
below for details on how to do
"Clearing the CMOS Configuration"
2 About Your BIOS
key. This will
below
30