Dhcpv4 Vlan Setting - ZyXEL Communications GS1915 Series User Manual

Figure 167 DHCP Relay Configuration Example

29.4.6 DHCPv4 VLAN Setting

Use this screen to configure your DHCP settings based on the VLAN domain of the DHCP clients. Click IP
Application > DHCP > DHCPv4 in the navigation panel, then click the VLAN link In the DHCP Status screen
that displays.
Note: You must set up a management IP address for each VLAN that you want to configure
DHCP settings for on the Switch.
Figure 168 IP Application > DHCP > DHCPv4 > VLAN
The following table describes the labels in this screen.
Table 120 IP Application > DHCP > DHCPv4 > VLAN
LABEL
VID
Relay
Remote
DHCP Server
1 .. 3
Option 82
Profile
Add
Cancel
Chapter 29 DHCP
DESCRIPTION
Enter the ID number of the VLAN to which these DHCP settings apply.
Use this section if you want to configure the Switch to function as a DHCP relay for this VLAN.
Enter the IP address of a DHCP server in dotted decimal notation.
Select a pre-defined DHCP option 82 profile that the Switch applies to all ports in this VLAN. The
Switch adds the Circuit ID sub-option and/or Remote ID sub-option specified in the profile to
DHCP requests that it relays to a DHCP server.
Click this to create a new entry or to update an existing one.
This saves your changes to the Switch's run-time memory. The Switch loses these changes if it is
turned off or loses power, so use the Save link on the top navigation panel to save your changes
to the non-volatile memory when you are done configuring.
Click Cancel to begin configuring this screen afresh.
GS1915 Series User's Guide
EXAMPLE
237