Static Multicast Forwarding Configuration - ZyXEL Communications GS1915 Series User Manual

Figure 101 No Multicast Forwarding

11.2 Static Multicast Forwarding Configuration

Click Advanced Application > Static Multicast Forwarding to see the following screen.
Figure 102 Advanced Application > Static Multicast Forwarding
The following table describes the labels in this screen.
Table 59 Advanced Application > Static Multicast Forwarding
LABEL
Active
Name
MAC Address
VID
Chapter 11 Static Multicast Forwarding
DESCRIPTION
Select this check box to activate your rule. You may temporarily deactivate a rule without
deleting it by clearing this check box.
Enter a descriptive name (up to 32 single-byte printable characters except [ ? ], [ | ], [ ' ], [ " ] or [
, ]) for this static multicast MAC address forwarding rule. This is for identification only.
Enter a multicast MAC address which identifies the multicast group. The last binary bit of the first
octet pair in a multicast MAC address must be 1. For example, the first octet pair 00000001 is 01 in
hexadecimal, so 01:00:5e:00:00:0A and 01:00:5e:00:00:27 are valid multicast MAC addresses.
You can forward frames with matching destination multicast MAC address to ports within a VLAN
group. Enter the ID that identifies the VLAN group here. If you do NOT have a specific target
VLAN, enter 1.
GS1915 Series User's Guide
136