Configure Vlan Port Settings - ZyXEL Communications GS1915 Series User Manual

Table 52 Advanced Application > VLAN > VLAN Configuration > Static VLAN Setup (continued)
LABEL
Tagging
Add
Cancel
Clear
VID
Active
Name
Delete
Cancel

9.6 Configure VLAN Port Settings

Use this screen to configure the static VLAN (IEEE 802.1Q) settings on a port. Click the VLAN Port Setup link
in the VLAN Configuration screen.
Figure 94 Advanced Application > VLAN > VLAN Configuration > VLAN Port Setup
Chapter 9 VLAN
DESCRIPTION
Select TX Tagging if you want outgoing traffic to contain this VLAN tag.
Otherwise, to ensure that VLAN-unaware devices (such as computers and hubs) can receive
frames properly, clear the TX Tagging check box to set the Switch to remove VLAN tags before
sending.
Click Add to save your changes to the Switch's run-time memory. The Switch loses these
changes if it is turned off or loses power, so use the Save link on the top navigation panel to save
your changes to the non-volatile memory when you are done configuring.
Click Cancel to begin configuring this screen afresh.
Click Clear to start configuring the screen again.
This field displays the ID number of the VLAN group. Click the number to edit the VLAN settings.
This field indicates whether the VLAN settings are enabled (Yes) or disabled (No).
This field displays the descriptive name for this VLAN group.
Select an entry's check box to select a specific entry. Otherwise, select the check box in the
table heading row to select all entries.
Click Delete to remove the selected entry from the summary table.
Click Cancel to clear the check boxes.
GS1915 Series User's Guide
124