External Connection Commands - Fluke 525B User Manual

525B
Users Manual
Common Commands (continued)
Command
*OPT?
*RST
*SRE
*SRE?
*STB?
*TST?
*WAI

External Connection Commands

Command
PRES_UNIT
PRES_UNIT?
RTD_TYPE
RTD_TYPE?
TC_REF
TC_REF?
TC_TYPE
TC_TYPE?
TSENS_TYPE
TSENS_TYPE?
5-2
Returns a list of the installed hardware and software options.
Resets the state of the instrument to the power-up state. This command
holds off execution of subsequent commands until it is complete.
(Overlapped command.)
Loads a byte into the Service Request Enable register (SRE).
Returns the byte from the Service Request Enable register.
Returns the status byte.
Initiates a series of self-tests, then returns a "0" for pass or a "1" for fail. If
any faults are detected, they are logged into the fault queue where they
can be read by the FAULT? query.
Prevents further remote commands from being executed until all previous
remote commands have been executed.
Sets the pressure display units.
Returns the pressure display units.
Sets the Resistance Temperature Detector (RTD) type.
Returns the Resistance Temperature Detector (RTD) type.
Sets whether the internal temperature sensor or an external reference
value is used for Thermocouple (TC) outputs and measurements.
Returns the source being used as a reference for thermocouple simulation
and measurements.
Sets the thermocouple (TC) temperature type.
Returns the thermocouple (TC) type.
Sets temperature sensor type.
Returns the temperature sensor type.
Description
Description