Table of Contents
Advertisement
5.
Remove the memory module/wireless module compartment cover (see
on page
6.
Remove the hard drive cover (see
Remove the keyboard:
1.
Remove the two Phillips PM 2.5×7.0 screws that secure the keyboard to the computer.
2.
Turn the computer display-side up, with the front toward you.
3.
Open the computer to a 90-degree position.
4.
Tip the computer back and rest it on the display enclosure.
5.
Insert a thin, flat-tip screwdriver (1) or other similar thin tool into the screw hole (2) in the wireless
module compartment and gently push on the back of the keyboard.
6.
Position the computer so that it rests on the base enclosure.
7.
Lift the rear edge of the keyboard (1) until it rests at an angle.
60
Chapter 4 Removal and replacement procedures
45).
Hard drive on page
53).
Memory module
ENWW
Advertisement
Table of Contents
