Compaq LTE 5100 Maintenance And Service Manual page 163

6. Disconnect the EasyPoint II controller cable [2] from the system board
(Figure 5-39).
7. Lift the keyboard out.
Reverse this procedure to install the keyboard.
NOTE: Be sure to connect the ground lugs at the rear of the keyboard.
5.9.2 Removing and Installing the EasyPoint II Controller
To remove the EasyPoint II controller, complete the following steps:
1. Remove the keyboard as described in Section 5.9.1.
2. Remove the two screws from the EasyPoint II controller
(Figure 5-40).