Removing An Sdram Module; Figure 2-3. Removing An Sdram Module - HP Compaq Evo N1010v Series Service Manual

Removing an SDRAM Module

(User-Replaceable)
The notebook has no system memory built into its motherboard, but has 2 slots for SDRAM modules.
One slot contains an SDRAM module that was factory installed.
NOTE: HP Pavilion ze5300, ze5200, ze4300, ze4200, and ze4100, HP Compaq nx9010, nx9005
and nx9000, Compaq Evo Notebook N1050v and N1010v, and Compaq Presario 2500, 2100, and
1100 notebooks use only DDR266 SDRAM modules. Using the wrong type of module prevents the
notebook from booting.
CAUTION: Handle the SDRAM module only by its edges and provide proper grounding,
or you might damage the module through electrostatic discharge.
Required Equipment
1 Phillips screwdriver
Removal Procedure
1. Unplug the AC adapter, if present, and then remove the battery.
2. On the bottom of the notebook, loosen the captive screws holding the SDRAM door, and
then remove the door.
3. Press outward on the latches at the sides of the SDRAM module to release it (the SDRAM
module pops up).
4. Carefully pull the SDRAM module out of the connector.
Service Manual

Figure 2-3. Removing an SDRAM Module

HP Pavilion 4x00, HP Compaq nx9005 and nx9000,
Compaq Evo Notebook N1050v and N1010v,
and Compaq Presario 2100 and 1100 Models
Removal and Replacement 2-5