HP Compaq Evo N1010v Series Service Manual page 124

Windows Management Instrumentation (WMI)
The Windows Management Instrumentation is basically sets of rules for accessing information about a
notebook WMI allows an application to determine, for example, the operating system being used, which
hardware and software components are in the notebook, and possibly whether any of the components need
replacing A local or remote application can use the WMI interface to check which hardware and software
components are installed on your notebook, and might be able to tell how well they are working or if they
need replacement
Installing the WMI Package
The WMI package is either preinstalled on the notebook's hard disk or can be downloaded from
http://wwwhpcom/toptools
installed before it can be used
To install the WMI preloaded on the hard disk:
1. Start Windows, if it is not already running.
2. Select Start > Programs (or All Programs) > Hewlett-Packard > HP Toptools Agent > Setup.
Using WMI
For a complete description of how to use WMI, see the following documentation provided with
the notebook:
•
A readme.txt file: select Start > Programs > Hewlett-Packard > HP Toptools Agent > Read me
•
A Windows online help file describing Hewlett-Packard's implementation of WMI (group and attribute
definitions): select Start > Programs Hewlett-Packard > HP Toptools Agent > HP Toptools Help
Uninstalling the WMI Package
1. Select Start > Programs (or All Programs) > Hewlett-Packard > HP Toptools Agent >
Uninstall WMI.
2. Restart the notebook.
3-32 Troubleshooting and Diagnostics
(the contents are the same in both cases) The package must be properly
Service Manual