Basic Operation - Icom IC-F60V Instruction Manual

Vhf/uhf transceiver
Hide thumbs Also See for IC-F60V:
Table of Contents

Advertisement

3

BASIC OPERATION

I Turning power ON
q Rotate [VOL] to turn power ON.
• When the opening vibration function is turned ON, the transceiver
vibrates for 2 sec. Ask your dealer for details.
w If the transceiver is programmed for a start up passcode, input
digit codes as directed by your dealer.
• The keys in the table below can be used for password input:
• The transceiver detects numbers in the same block as identical.
Therefore "01234" and "56789" are the same.
KEY
0
1
NUMBER
5
6
e When the "PASSWORD" indication does not clear after inputting
4 digits, the input code number may be incorrect. Turn the power
off and start over in this case.
I Channel selection
Several types of channel selections are available. Methods may dif-
fer according to your system set up.
NON-ZONE TYPE:
Push [CH Up]/[CH Down] to select the desired operating channel
in sequence; or, push one of [MR-CH 1] to [MR-CH 4] to select a
channel directly.
ZONE TYPE:
Push [Zone] then push [CH Up]/[CH Down] to select the desired zone.
AUTOMATIC SCAN TYPE:
Channel setting is not necessary for this type. When turning the
power ON, the transceiver automatically starts scanning. Scanning
stops when receiving a call.
14
or
2
3
4
7
8
9
I Call procedure
When your system employs tone signalling (excluding CTCSS and
DTCS), the call procedure may be necessary prior to voice trans-
mission. The tone signalling employed may be a selective calling
system which allows you to call specific station(s) only and prevent
unwanted stations from contacting you.
q Select the desired TX code channel or 2/5-tone code according
to your System Operator's instructions.
• This may not be necessary depending on programming.
18
19
• Refer to pgs.
,
for selection.
w Push [Call] (assigned to one of the dealer programmable keys).
e After transmitting, the remainder of your communication can be
carried out in the normal fashion.
Selective calling
3
BASIC OPERATION
1
2
3
4
5
6
7
8
9
10
Non-selective calling
11
12
13
14
15
16
17
18
19
20
15

Advertisement

Table of Contents
loading

This manual is also suitable for:

Ic-f50v

Table of Contents