Table of Contents
Advertisement
2
PANEL DESCRIPTION
EMERGENCY KEYS
Push and hold to transmit the emergency call.
• The emergency call is transmitted with beep emission and no display
changes.
• The transceiver can transmit the emergency call silently or with the
display changes depending on the pre-setting. Ask your dealer for de-
tails.
• If you want to cancel the emergency call, push and hold the key again
before transmitting the call.
• The emergency call is transmitted one time only or repeatedly until re-
ceiving a control code depending on the pre-setting.
TX CODE ENTER KEY (PMR operation only)
Push to enter the TX code edit mode. Then set the desired digit
using [CH Up]/[CH Down]. (p. 19)
TX CODE CHANNEL SELECT KEY
➥ Push to enter the TX code channel selection mode. Then select
the desired channel using [CH Up]/[CH Down]. (p. 18)
➥ While in the TX code channel selection mode, push and hold for
1 sec. to enter the TX code edit mode. Then set the desired digit
using [CH Up]/[CH Down]. (p. 19; PMR operation only)
TX CODE CHANNEL UP/DOWN KEYS
Push to select a TX code channel directly.
ID-MR SELECT KEY (PMR operation only)
➥ Recalls detected ID codes.
• Push this key, then push [CH Up]/[CH Down] for selection.
• Up to 5 ID's are memorized.
➥ Push and hold to erase the selected memorized ID's.
VOICE SCRAMBLER FUNCTION
Push to turn the voice scrambler function ON and OFF.
12
COMPANDER KEY
Push to turn the compander function ON and OFF.
The compander function reduces noise components from the trans-
mitting audio to provide clear communication.
USER SET MODE KEY
➥ Push and hold to enter user set mode.
• During user set mode, push this key to select an item, and push
[CH Up]/[CH Down] to change the value or condition.
➥ Push and hold this key again to exit user set mode.
• User set mode is also available via the 'Power ON function'. Please
20
refer to p.
also.
PLAYBACK KEY (p. 23)
➥ Push to playback the recorded messages in sequence from the
newest one.
• A short beep is emitted after playing back each message.
• A long beep is emitted after playing back all messages.
• An error beep is emitted when no message is in the memory.
➥ While playing back the message, push and hold for 1 sec. to
delete the selected message.
PLAYBACK/REC KEY (pgs. 22, 23)
➥ Push to playback the recorded messages in sequence from the
newest one.
• A short beep is emitted after playing back each message.
• A long beep is emitted after playing back all messages.
• "NO REC" is displayed when no message is in the memory.
➥ Push and hold for 1 sec. to start recording. And then, push again
to stop recording.
➥ While playing back the message, push and hold for 1 sec. to
delete the selected message.
2
PANEL DESCRIPTION
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
20
13
Advertisement
Table of Contents
