Advertisement
General Problems
Problem
?
THE PAPER MISFEEDS
PAPER DOES NOT FEED FROM
THE PAPER TRAY
I DON'T KNOW HOW TO CHANGE
THE PAPER SIZE
THE OUTPUT IS NOTICEABLY
CURLED AND UNEVEN
THE IMAGE IS SKEWED ON THE
PAPER
LINES APPEAR IN THE IMAGE
SMUDGES APPEAR ON PRINTED
OUTPUT
WHEN PRINTING ON THICK PAPER,
THE PRINT RESULT IS DIRTY FROM
THE 2ND PAGE ON
I DON'T KNOW HOW TO CHANGE
THE OUTPUT TRAY
PART OF THE IMAGE IS CUT OFF
PRINTING TAKES PLACE ON THE
WRONG SIDE OF THE PAPER
A COVER OR INSERT IS NOT
PRINTED ON THE SPECIFIED
PAPER
Check
Is a torn piece of paper remaining in the machine?
Is too much paper loaded in the tray?
Are multiple sheets feeding at once?
Are you using paper that is not within the specifications?
Are the bypass tray guides adjusted to the width of the paper?
Is the bypass tray extension guide pulled out?
Is the bypass feed roller dirty?
Is A5 (5-1/2" x 8-1/2") size paper loaded?
Is the paper size specified?
Did you add paper to the bypass tray?
Are you using punched paper?
Are you using label sheets that cannot be used?
Remove the paper, turn it over, and reload it. Using a different paper
type may solve the problem.
Did you load an envelope?
Is the paper loaded correctly into the paper tray?
Has the tray been prohibited in some modes (copy, print, fax, image
send, document filing)?
Set the paper size used in each tray in the tray settings.
Remove the paper, turn it over, and reload it. Using a different paper
type may solve the problem.
Is too much paper loaded into the bypass tray?
Are the bypass tray guides adjusted to the width of the paper?
Are the original guides adjusted to the width of the paper?
Is the control plate auxiliary block attached to the tray? (When using
SRA3)
Are you scanning originals of mixed width? (In a reversing single pass
feeder (RSPF))
Are the scanning areas of the document glass or automatic document
feeder dirty?
Is the bypass feed roller dirty?
Did you clean the main charger of the photoconductive drum?
Did you clean the PT charger of the primary transfer belt?
Did you clean the laser unit?
Did you execute Black Streak Reduction of system setting?
Are you using paper that is not within the specifications?
Are you printing on pre-punched paper?
Does a message appear indicating the need for maintenance?
Remove the paper, turn it over, and reload it. Using a different paper
type may solve the problem.
Has the paper type been set correctly?
Did you change the output tray?
Has the correct paper size been set?
Was the original placed in the correct position?
Is the paper loaded with the print side facing in the correct direction?
Has the paper type been set correctly?
8
Page
14
14
14
14
14
14
14
14
15
15
15
15
15
15
15
15
15
16
16
16
16
16
16
17
17
17
17
17
17
17
17
17
17
18
18
18
18
19
19
Hide quick links:
Advertisement
