Sharp MX-3071 Troubleshooting Manual page 14

General Problems
THE ORIGINAL MISFEEDS (AUTOMATIC DOCUMENT
?
FEEDER)
Check
Is too much paper loaded into the
document feeder tray?
Is the original a long original?
Is the original on thin paper?
Is the feed roller dirty?
(In a reversing single pass feeder
(RSPF))
THE PAPER MISFEEDS
?
Check
Is a torn piece of paper remaining in
the machine?
Is too much paper loaded in the tray?
Are multiple sheets feeding at once?
Are you using paper that is not within
the specifications?
Are the bypass tray guides adjusted
to the width of the paper?
Is the bypass tray extension guide
pulled out?
Is the bypass feed roller dirty?
Is A5 (5-1/2" x 8-1/2") size paper
loaded?
Solution
!
■ Make sure that the stack of paper in the tray is not higher than the indicator line.
► Placing the original and adding paper (page 5)
■ When using the automatic document feeder to scan a long original, set the scan
size to [Long Size].
(Note that long originals cannot be copied using the copy function.)
■ Use the document glass to scan the original.
If you need to use the automatic document feeder, use [Slow Scan Mode] in
[Others] to scan the original.
■ Clean the surface of the paper feed roller.
► Maintenance (page 6)
Solution
!
■ Follow the instructions in the touch panel to remove all paper.
■ Reload the paper. Load no more than the maximum number of sheets and do not
exceed the indicator line.
► Placing the original and adding paper (page 5)
■ Fan the paper well before loading it.
■ Use SHARP-recommended paper.
Using paper that is for other models or special paper that is not supported may
result in misfeeds, creases, or smudges.
 - "SUPPLIES" in Start Guide
For paper that is prohibited or not recommended, see User's Manual.
■ Adjust the bypass tray guides to the width of the paper so that they slightly
contact the sides of the paper.
► Placing the original and adding paper (page 5)
■ When loading large-size paper, pull out the extension guide.
► Placing the original and adding paper (page 5)
■ Clean the surface of the bypass feed roller.
► Maintenance (page 6)
■ When loading A5 (5-1/2" x 8-1/2") size paper, place the paper in the horizontal
(A5R (5-1/2" x 8-1/2"R)) orientation. (Excluding tray 1 and the bypass tray)
14